How to Root Walton Primo H10 without twrp

Rooting is the way to obtain Supersu Right’s on a Android device, that means after Rooting the Phone you have (sudo) full Right to perform any system task.after rooting the phone you can replace any system app & settings, you can run any specialized app that require administrator or sudo right.. if you own a android smartphone and want to root it then you can do it by following below Instructions..

Requirement:

  • vbmeta.img
  • unlock bootloader by following this guide
  • ROM2box and required USB driver: Download

Note:

  • all userdata will be erased, must make a backup before process
  • Must write vbmeta.img after unlocking bootloader
  • if the device has a vendor_boot partition patch & flash it too
  • we strongly suggest below method (boot.img dump) because boot.img from a different firmware version may cause bootloop
  • the boot image is NOT the bootloader image. do not confuse between them flashing the wrong image to bootloader could brick your device

How to Root Walton Primo H10:

  • Install USBDK and Mediatek driver on Your computer
  • Download & Extract ROM2box
  • Run ROM2Box.exe
  • Click Mediatek/Firmware Reader!
  • mark “Full Firmware”
  • click ‘START’ button
  • Once the process Started, turn Phone OFF, Now together Press Volume up + down key & Insert USB, Once Phone detected Immediate Release key (make sure your phone stable in device manager)
  • done, it will take 15-20Min
  • Move boot.bin or boot_a.bin (rename it boot.img) from ROM2box/out folder to your phone

Note: if you wish to skip above steps then copy boot.img from stock firmware instead dump (make sure it’s from Installed firmware version)

  • Now patch boot.img using Magisk
  • Download this root.zip & extract it
  • Move patched_boot.img (rename boot.img) and vbmeta.img to root folder
  • run root.bat & connect phone in fastboot mod
  • wait until Success !

done, Your phone successfully rooted.

Related: