Nubia Z60 Ultra NX721J Flash File Firmware:
Stock Firmware refers to the version of the operating system that comes pre-installed on a device by the manufacturer. It is an unmodified version of the firmware that is distributed with a device and can be used to restore it to its original State.
Nubia Z60 Ultra NX721J Stock Firmware is useful for fixing serious issues such as hang on Logo, frp lock, fastboot Mode, display Blank or white after flash, dead recovery, dead after flash etc. for restoring a device to its original configuration. Stock ROMs are often specific to a particular device and are not interchangeable between different devices.
Note:
- make a backup before Process
- it will erase all your data Including Internal storage
Firmware Information: |
|
|---|---|
| Device Name | Nubia Z60 Ultra NX721J |
| ROM Type | Full ROM |
| SoC | Qualcomm 8 Gen3 |
| OS | Android 14 |
| Password | Null |
| Root Access | No |
| Region | check below list |
| Firmware Version | check below list |
Download Links:
Available Firmware:
- MyOS14.0.10-Full-OTA-GLO
- MyOS14.0.18MR_NX721J-CN OTA
- Firmware Z60 ultra Dead boot Repair, Convert Global Locked bl.zip
- Contact Me for convert global, root, unbrick, FRP, Reset & Region change (Paid)
Flash Tools:
- QFIL/QPST: Download
USB Driver:
- QD Loader driver: Download
How to Install Stock Firmware on Nubia Z60 Ultra NX721J:
- Install QFIL: Download and install the latest Version of QFIL on your computer.
- Download the firmware: Download the firmware file for your from above download section.
- Extract Firmware File: once firmware file is downloaded extract the zip file using the 7z or winrar.’
- Install Qualcomm driver: download & Install latest Qualcomm 9008 usb driver on your computer
- Boot your device into EDL mode: To put your device into EDL (Emergency Download) mode, follow these steps:
- turn off your device.
- Hold down the volume up and volume down buttons simultaneously.
- While holding the volume buttons, Connect Your Device to your computer Via USB Cable.
- Your device should now be in EDL mode. check device manager like below image
- Note: if still not in EDL Mod then you have to short test point
- Launch QFIL: Launch QFIL on your computer.
- Change QFIL Settings: Go to Setting and set it like below Image
- Load the firmware: In QFIL, click on the “Flat Build” button and select the firmware file that you downloaded in step
- in the Programmer option click browse and locate Prog-firehose-ddr.elf file from firmware folder
- Click load xml option and select all rawprogram and Patch xmls
- Start the flashing process: Click on the “Download” button in QFIL to start the flashing process.
- Wait for the flashing process to complete: The flashing process can take several minutes to complete, depending on the size of the firmware file and the speed of your computer. do not disconnect your device from the computer during this time.
- Reboot your device: Once the flashing process is complete, disconnect your device from the computer and reboot it.
Install using Fastboot:
make sure bootloader is unlocked
- extract payload.bin and send below every partition like this
fastboot flash 'partition name' 'filename'
replace partition name and filename with exact partition and file
Install using Stock Recovery:
adb sideload filename
With this Method you can flash only Stock ROM
Read also: