Red Magic 9s Pro NX769s Global & China ROM:
Stock Firmware refers to the version of the operating system that comes pre-installed on a device by the manufacturer. It is an unmodified version of the firmware that is distributed with a device and can be used to restore it to its original state.
The Red Magic 9s Pro runs on Android 14 operating system, powered by a Qualcomm 8Gen2 Processor. it is a dual SIM smartphone that support nano sim card. connectivity options include 5G, GPS, WIFI, Bluetooth etc. The device come with 12GB of RAM and 512GB of storage.
Note:
- make a backup before Process
- it will erase all your data Including Internal storage
Download Links:
Available Firmware:
- Red Magic 9 Pro V9.5.10 Asia OTA: Download
- Red Magic 9 Pro V9.5.08 Europe OTA: Download
- RedMagicOS 9.5.15 original 9s china dead boot repair file: Download
- RedMagicOS V9.5.08 original 9s Global dead boot repair file: Download
- Contact Me for unlock, root, unbrick, FRP, Reset & Region change (Paid)
Flash Tools:
- QFIL/QPST: Download
USB Driver:
- QD Loader driver: Download
History:
- RedMagicOS9.5.9_EDL_9008
- RedMagicOS9.5.15_EDL_9008
- RedMagicOS9.5.19_EDL_9008
- RedMagicOSV9.5.08_GB_9008
- RedMagicOSV9.5.10_GB_9008
- RedMagicOSV9.5.10_GB_FOTA
- RedMagicOSV9.5.08_GB_FOTA
How to Install Stock Firmware on Red Magic 9s Pro:
- Install QFIL: Download and install the latest version of QFIL on your computer.
- Download the firmware: Download the firmware file for your from above download section.
- Extract Firmware File: once firmware file is downloaded extract the zip file using the 7z or winrar.’
- Install Qualcomm driver: download & Install latest qualcomm 9008 usb driver on your computer
- Boot your device into EDL mode: To put your device into EDL (Emergency Download) mode, follow these steps:
- Turn off your device.
- Hold down the volume up and volume down buttons simultaneously.
- While holding the volume buttons, Connect Your Device to your computer Via USB Cable.
- Your device should now be in EDL mode.
- Note: if still not in EDL Mod then you have to short test point
- Launch QFIL: Launch QFIL on your computer.
- Load the firmware: In QFIL, click on the “Flat Build” button and select the firmware file that you downloaded in step
- in the Programmer option click browse and locate Prog-firehose-ddr.elf file from firmware folder
- Click load xml option and select rawprogram and Patch xmls
- Start the flashing process: Click on the “Download” button in QFIL to start the flashing process.
- Wait for the flashing process to complete: The flashing process can take several minutes to complete, depending on the size of the firmware file and the speed of your computer. do not disconnect your device from the computer during this time.
- Reboot your device: Once the flashing process is complete, disconnect your device from the computer and reboot it.
Read also: