How to unbrick Realme 9i + bypass Pattern lock

unbrick is a process to repair a device that was bricked, with in Realme 9i user face two type of brick- soft brick and hard brick.

Soft brick: in this stage device stuck or freez on boot logo or animation due to any software/ firmware issue.

hard brick: in this stage device completely goes dead and does not show any sign of boot for example logo or animation, even fastboot or recovery mod. it show only 9008 USB COM driver /device when we connect it to computer

so if your Realme 9i having any of soft or hard brick issue then you can fix it by following the below Instructions.

Requirement’s

Note:

  • don’t try on working phone, must make a qcn or efs backup otherwise very difficult to repair IMEI

Steps to unbrick Realme 9i:

  • Download unbrick tool from above
  • Install qcom 9008 usb driver on your computer
  • Run tool
  • Connect Phone in EDL Mod
  • once COM detected mark Method 1 & click ‘Connect Device‘ button
  • under the Firmware Flash locate extracted ofp Firmware
  • Click ‘FIRMWARE FLASH‘
  • wait until success, done

How to bypass Pattern Lock on Realme 9i:

  • Download unbrick tool from above
  • Install qcom 9008 usb driver on your computer
  • Run tool
  • Connect Phone in EDL Mod, Go to recovery mod, insert usb cable multiple time press recovery version

  • once COM detected mark Method 1 & click ‘Connect Device‘ button
  • then Click ‘Factory Reset‘
  • once done disconnect device, press all three button for 1 Min

have any question Let Me know Via comment.