How to unbrick Motorola G9 Power QCOM 9008 EDL Mod

unbrick is a process to repair a device that was bricked, with in Motorola G9 Power user face two type of brick- soft brick and hard brick.

Soft brick: in this stage device stuck or freez on boot logo or animation due to any software/ firmware issue.

hard brick: in this stage device completely goes dead and does not show any sign of boot for example logo or animation, even fastboot or recovery mod.

so if your Motorola G9 Power having any of soft or hard brick issue then you can fix it by following the below Instructions.

Requirement’s

  • Laptop, PC
  • QCOM 9008 USB driver: Download
  • unbrick file for Motorola G9 Power: Download
  • fastboot Firmware for Motorola G9 Power: Download

Steps to unbrick Motorola G9 Power:

  • Download & extract fastboot firmware
  • download & Extract unbrick file for Motorola G9 Power
  • Install QCOM 9008 USB driver on your computer
  • Install adb fastboot driver on your computer
  • Now connect your phone to computer by Pressing volume up & down key (if device not detected in QCOM 9008 USB COM then you have to do test pointshort test point) you can see your device in device manager like below image

  • Open unbrick file folder and Run blank-flash.bat, wait until success, once done, your phone rebooted in fastboot mod
  • open fastboot firmware folder and Run flash_all.bat, wait until success, your Phone successfully rebooted, done.

have any question Let Me know Via comment.