Flashing Xiaomi Mi CC9 no fastboot mod No Recovery:
Step by Step Guide to Flash Xiaomi Mi CC9. by using this Method you can Flash Xiaomi Mi CC9 even if it does Not have fastboot & recovery mod access & also does Now have a Authorized Mi account. this Method Properly tested and Working on this devices. You Must have basic device disassemble Knowledge to Perform test point.
Pre-Requirements
- disassemble Your Phone (Require for test Point)
- First Make a Complete backup of Your Personal data (if Possible)
- Charge the device at least 50% to prevent accidental shut down during the process
Downloads:
- QCOM Driver: Download
- Mi Flash tools: Download
- Xiaomi Mi CC9 No Auth Firehose: Download
- Xiaomi Mi CC9 Latest Flash File: Download
- Note: You can use QPST Instead MI Flash tools.
Instructions:
- Download and Install 9008 QCOM Driver On PC
- Download & Extract MI Flash
- Extracted Fastboot Firmware
- Now Replace Firehose file in Firmware folder by Downloaded one
- Run MI Flash & Locate the Fastboot Firmware Folder
- Connect Your Switched of Phone to PC & Click Start
- take a Coper Wire and Short the Pinout as Show in below image
- You can see Flashing Process On Screen. after Complete unplug & Switch it On
- done wait until Success.