ISP Pinout is a set of pins on the board of Vivo Y15s that allows for programming or firmware updating via supported software like Jtag and UFI Box. The ISP pinout provides a standardized interface for connecting a programming tool or hardware device to the Microcontroller, enabling the device to be reprogrammed without the need for removing it from the circuit board.
Here are some common interfaces and their corresponding pinouts used for programming and debugging on smartphones:
- USB – Most smartphones use USB interfaces for programming and debugging. The USB interface consists of several pins including VCC, GND, D+ and D-.
- UART – Some smartphones also use UART interfaces for programming and debugging. The UART interface consists of several pins including RX, TX, VCC, and GND.
- JTAG – JTAG is a standard interface used for programming and debugging microcontrollers and other embedded devices.
- SWD – SWD or Serial Wire Debug is a two-pin interface used for programming and debugging ARM microcontrollers.
How to use:
- you can use with any supported tool Box Like Jtag or UFI
Vivo Y15s ISP Pinout image
