How to unbrick Motorola G Pure (Mediatek USB COM)

unbrick is a process to repair a device that was bricked, with in Motorola G Pure user face two type of brick- soft brick and hard brick.

Soft brick: in this stage device stuck or freez on boot logo or animation due to any software/ firmware issue.

hard brick: in this stage device completely goes dead and does not show any sign of boot for example logo or animation, even fastboot or recovery mod.

so if your Motorola G Pure having any of soft or hard brick issue then you can fix it by following the below Instructions.

Requirement’s

Steps to unbrick Motorola G Pure:

  • Download & extract fastboot firmware
  • download & Extract unbrick file for Motorola G Pure
  • Install Mediatek VCOM USB driver on your computer
  • Install adb fastboot driver on your computer
  • Now connect your phone to computer by Pressing volume up & down key (if device not detected in Mediatek VCOM then you have to do test pointshort test point)
  • Open unbrick file folder and Run blank-flash.bat, wait until success, once done, your phone rebooted in fastboot mod
  • open fastboot firmware folder and Run flash_all.bat, wait until success, your Phone successfully rebooted, done.

have any question Let Me know Via comment.