unbrick is a process to repair a device that was bricked, with in Motorola Edge 2021 XT2141-2 user face two type of brick- soft brick and hard brick.
Soft brick: in this stage device stuck or freez on boot logo or animation due to any software/ firmware issue.
hard brick: in this stage device completely goes dead and does not show any sign of boot for example logo or animation, even fastboot or recovery mod. it show only 9008 USB COM driver /device when we connect it to computer
so if your Motorola Edge 2021 XT2141-2 having any of soft or hard brick issue then you can fix it by following the below Instructions.
Requirement’s
- Laptop, PC
- QCOM 9008 USB driver: Download
- unbrick file for Motorola Edge 2021 XT2141-2: Download
- fastboot firmware for Motorola Edge 2021 XT2141-2: Download
Steps to unbrick Motorola Edge 2021 XT2141-2:
- Download & extract fastboot firmware
- download & Extract unbrick file on your computer
- Install QCOM 9008 USB driver on your computer
- Install adb fastboot driver on your computer
- Open unbrick file folder and Run blank-flash.bat, it will waiting for USB device
- Now connect your phone to computer by Pressing volume up & down key (if device not detected in QCOM 9008 USB COM then you have to do test point/ short test point) you can see your device in device manager like below image
- if everything is ok you will see flashing process
- once done your phone rebooted to fastboot mod
- open fastboot firmware folder and Run flash_all.bat, wait until success, done
have any question Let Me know Via comment.