bypass huawei ID on honor 8A:
FRP or Factory Reset protection or huawei ID Lock is a security feature on honor 8A which is automatically activated when you set up a huawei ID on Your device. Once Huawei ID is activated, it prevents use of a device after a factory data reset, until you log in using same account.
If you are facing same huawei ID Lock issue on your device then you can fix it by following the below instructions.
honor 8A Run on Android 9.0 & it is Powered by Mediatek helio G35 Processor. it is a dual SIM smartphone support Nano SIM card, connectivity options Include GPS, bluetooth, hotspot, WIFI, 3G & 4G. The device come with 2/3GB of RAM and 32/64GB of storage that can be expandable via SD card.
Note:
- it will completely remove Huawei account and it’s data from from device
- some apps not works after account bypass. you have to re-write oeminfo partition
Download:
- Mediatek driver: Here
- SP Flash tools: Download
- DA File: Included IN account remove file
- FRP/huawei ID Remove File honor 8A: Download
Steps to bypass huawei ID on honor 8A:
- Download & Extract SP Flash tool & account bypass File
- Install Mediatek USB Driver on Your computer. Run SP Flash tools
- Click download agent and locate DA File file from account remove file
- Click Authentication File and load Auth File from account remove file
- Click on chose scatter File and locate the scatter File from account remove file
- it will automatically load require files, just connect your switched off Phone to computer by Pressing volume up & down key (if device not detected then you have to do test Point)
- select format menu and mark manual format flash
- copy paste below address according your requirement
Huawei ID Remove
Begin address : 0x4900000
Format length : 0x2000000
- Then click start, once done
- Go back to download tab
- on SP Flash tool select download only from drop down & click download. You will see a Yellow bar With Process. once done disconnect device and start it.
Note: if No keyboard issue after Huawei ID bypass, then Rewrite oeminfo.img file using SP Flash tool or CM2.