The EDL test point is a specific contact area on the Realme C65 RMX3910’s motherboard that allows the device to enter Emergency Download Mode when shorted. This hardware-level method is essential when the phone becomes bricked, stuck in boot loop, or unresponsive. Once in EDL mode, the device can interface with a computer using an EDL Flash Tool to flash firmware and recover functionality.
To put your Realme C65 RMX3910 into EDL mode via test point, follow the instructions carefully below. This method is effective when system-based options (like ADB or Fastboot) aren’t working.
Note:
- This process involves opening the device, which may void warranty or cause damage if not done correctly.
- Proceed only if you’re confident or experienced with hardware disassembly.
How to Reboot Realme C65 RMX3910 into EDL Mode Using Test Point:
- Install the required EDL USB driver on your PC.
- Power off the device completely.
- Gently remove the back cover and any shielding to access the motherboard.
- Locate the EDL test point as shown in the image below.
- Short the test point using a copper wire or tweezer, then connect USB cable to PC.
- Check the Device Manager — it should show as “MTK Preloader or BROM device”.
- If the device isn’t detected, retry the shorting process and ensure drivers are correctly installed.
Test Point image for Realme C65 RMX3910:
Why Use Test Point?
- Device is hard-bricked or unresponsive
- Bootloader or recovery is corrupted
- FRP lock removal when no ADB or Fastboot access
- To flash official firmware without unlocking bootloader