Motorola G52 XT2221-1-DS Firmware (Stock ROM)

Download Motorola Moto G52 XT2221-1-DS Firmware Flash File:

Official Stock Firmware Now available for Motorola G52 XT2221-1-DS & You can download it from below. by using this firmware you can solve all software Issues with in your Motorola G52 XT2221-1-DS such as hang on Logo, frp lock, Fastboot Mode, display blank or white after Flash, dead recovery, dead after flash etc.

Motorola G52 XT2221-1-DS Run on Android 12 & it is Powered by QCOM SD680 Processor. it is a dual SIM smartphone support Nano SIM card, connectivity features Include GPS WIFI hotspot Bluetooth 3G & 4G. The device come with 4GB of RAM and 128GB of Storage that can be expandable via SD card.

Pre-Requirement’s

  • First Make a complete backup of device
  • charge the device at least 50% to prevent accidental shut down during the process

Firmware Information:

Device Name: Motorola G52 XT2221-1-DS
Type: Full ROM
Size: up to 2-4GB
SoC: QCOM SD680
Os: Android 12
Password: Null
Root access: Not
Gapps: Included
Carrier: Check Below List
Firmware Version: RHODE_G_S1SR32.38-87-2

Download Links:

  • RHODE_G_S1SR32.38-40-2_ Retail INDIA: Download
  • RHODE_G_S1SR32.38-87-2 Retail EURO : Download

Flash Tools:

usb Driver: 

How to Install Stock Firmware on Motorola G52 XT2221-1-DS:

  • Download & Extract Firmware & RSD Lite tool
  • Install RSD Lite and usb driver on computer
  • after extracting the Firmware you will see an XML file “XXX” then open the file with notepad. Remove all lines with the word “getvar” there were two lines that have the word “getvar”, then save. (Note: Skip if No getvar)
  • Open RSD Lite, Press the “…” Next to the Filename. Find and select the XML file that has been edited in step No.3
  • Reboot phone to bootloader by pressing volume down & power key
  • Connect Phone to computer by using the usb cable
  • Click Download/start, wait until done. once done unplug Phone and switch it ON

Method 2:

  • Reboot phone to bootloader by pressing volume down & power key
  • Connect Phone to computer by using the usb cable
  • Go to firmware folder and Run flash-all.bat wait until success, once done disconnect device and switch it ON..
Read also: