How to Repair IMEI Number on Tecno Spark Go 2020

IMEI Number or International Mobile Equipment Identity is a Number to identify a Mobile Phone. all GSM network use IMEI Number to validate the device. if you have Loss IMEI Number on Your Tecno Spark Go 2020 due to any software issue then it is not able to connect to any Network. In this condition You can Repair it’s IMEI Number by following the below Instructions.

Tecno Spark Go 2020 Run on Android 10 & it is Powered by Mediatek MT6761 Processor. it is a dual SIM (GSM) smartphone support Nano-SIM cards. connectivity options Include Wi-Fi, GPS, Bluetooth, USB OTG, FM, 3G & 4G. The device come with 3GB of RAM & 32GB of Internal Storage that can be Expandable via SD card.

Note:

  • To write a serial Number of 0123456789ABCDEF for example, we’ll assume that Product number is 11223344556677889900XYZ. Bardcode of 63 characters would then be 11223344556677889900XYZ0123456789ABCDEF************************

Download Links:

Steps:

  • wipe NV Partition using fastboot
fastboot erase nvdata
fastboot erase nvram
  • Disable SLA Authentication (if needed) by following this guide
  • unzip Maui META, install it on the PC then run as Administrator. It should be installed to Program files or Program files (x86) folder depending on your PC’s architecture.
  • Wait till the Maui META dashboard appears with a red circle. Under Connection Type, select the option which best describes your device
  • Click Reconnect at the top-right corner. The color of the circle should start changing between red and green. Switch off the phone (still with battery inside) and connect it to the PC without holding any button on the phone.
  • The phone should boot up then Get stuck at boot animation. Not to worry,its in META mode. The circle should now be yellow in color, indicating that the phone has been successfully detected
  • In the Get Version box, click Get target version to confirm that the phone has been detected. The phone’s details should appear
  • You can now minimize the Get version box

  • Click on the Dropdown at the top left corner and select IMEI download

  • The IMEI Download box should pop up. Click on Change NVRAM Database File
  • In the window that pops up, navigate to the location of the BPLGUInfo file (often named like BPLGUInfoCustomAppSrcP_MT65**…), select it then click Open

  • You should see the path to the DB file under NVRAM Database File. Click SIM_1 or SIM_2 depending on which you wish to write IMEI to. Now, enter the first 14 digits of the IMEI you wish to write. The digit entered in the CheckSum box will be the 15th digit of the IMEI. Once done, click Download To Flash (If IMEI keeps disappearing after factory reset then try clicking Upload From Flash instead)

  • Once the IMEI has been successfully written to the selected SIM slot on the phone, you should see a message at the bottom saying Download IMEI to flash successfully
  • Run SP Flash tool & write cust Partition from ENG Firmware
  • switch off the Phone either by taking out then reinserting the battery or holding the power button till it goes off. Once off, boot up the phone and dial *#06# to confirm that the IMEI was successfully written to the phone.

LEAVE A REPLY

Please enter your comment!
Please enter your name here

9 − six =